Hair Care Tips

Washing your Unit

Items needed – Moisturizing Shampoo and Conditioner

Plastic bag(for deep conditioning, optional)

  1. Wash the unit in a downward motion with shampoo and lukewarm water, 2 times.
  2. Rinse the shampoo.
  3. Saturate the hair with conditioner.
  4. Leave the conditioner on for 5-10 mins.

*For deep conditioning- once you have applied the conditioner to the hair, place the hair in a plastic bag for 30-45 minutes.

 

  1. Rinse the conditioner.
  2. Use the connected straps to hang the hair in a    dry place to fully dry.
  3. Once the hair is dry, refer to the ‘Setting Your Part’ instructions and style your hair as desired.

 

Setting your Part

Items needed - setting foam, holding spray (light to medium hold), comb, curling iron or wand (we prefer to use a wand)

  1. Using a comb part your hair in the desired position.
  2. Once your hair is parted, apply the setting foam to the section that is parted.
  3. Once you have massaged in the foam, spray the section with the holding spray.
  4. Comb the parted hair into the desired style
  5. Immediately after, Go over the parted hair with the curling Iron or wand. Keep going over the parted hair with curling Iron and wand until satisfied.
  6. Once satisfied with the part, comb the section and that’s it!

 

Installation

  1. Turn the Unit inside out and use a makeup blush brush to dust under the lace with pressing powder that matches the color of your skin
  2. Use the black wig band as extra support for your unit.
  3. Connect the ends into the loops in the unit and adjust the band to your preference(similar to a bra strap)

*Be sure to hook the band that is attached to the unit as well.

 

Cutting your Lace

We recommend that you use small scissors to cut your lace.

  1. Start with cutting a straight line in the middle of lace(middle-part) dividing the lace into 2 pieces.
  2. From the middle cut along your hair line leaving about 2 cm of lace in front of your hair line. **IMPORTANT: cut in a loose zig zag motion.. DO NOT CUT A STRAIGHT UNIFORM LINE. This will help make your unit look more natural.
  3. Once you have cut the first side, repeat this step again for the other side.